Brass Compression Fitting Male Connector

Product Description

Brass Compression Fitting Male Connector

The Compression fittings are extensively use because of its simplicity efficiency low cost and easy of assembly

Assembly Instructions

1 Slide nut Sleeve onto tubing The thread end of the nut must face out

2 Insert the tube into the fitting Be sure the tube is bottomed on the fitting shoulder

3 Assemble nut to body and tighten the nut

MaterialsElbow and Tees

Brass forgingsPioneer compression fittings are made from BS218 material The exceptional strength of forge fittings Over 80 stronger than castings provides an extra safety factor

Connectors Unions and Nuts

Stress relieved brass bar stockBS249

Temperature Ranges

From  65oF  250oF

Vibration

Fair resistance to vibration or tube movement depending on applications involved Use long nut for additional resistance to vibration

Applications

Use with copper brass and aluminium Not recommended for steel tubing manufactured for low  medium pressure tubing connection work where excessive vibrations or tube movement is not involved This fittings is widely used for connecting gasoline grease oil water vacuum and air lines

Working Pressure Ranges

Temperature and type of tubings used are important factors However the following table is good guide for proper selection at temperature 60 F

PSI TUBE Tube Wall

ODin in

400 18  030

400 316  030

300 14  030

300 516  032

200 38  032

200 12  032

150 58  035

100 34  035

75 78  035

Ordering Information

To order simply specify catalogue number for configuration and size desired

Example

14 tube X 14 BSP

ion fittings